AIPTEK A-HD Manuel d'utilisateur télécharger pdf (Page 5)

To insert a memory card, do the following:

(1) Press the PushEXWWRQ¿UVWDQGVOLGHWKHEDWWHU\FRPSDUWPHQW

cover down.

*HQWO\SXVKWKHFDUGZLWKWKHFRQQHFWRUVJROGHQ¿QJHUVWR

the top until the card reaches the bottom of the slot.

To remove the memory card, gently push the card and it will pop

up. Then pull the card out of the slot.

Inserting a memory card (optional)

3OHDVHFKDUJHWKHEDWWHU\IRUDWOHDVWKRXUVSULRUWRLWV¿UVWXVH$IWHUZDUGVLWZLOOWDNH

approximately 3 hours to fully charge the battery by AC adapter.

1. Connect the cable.

Connect one end of the supplied AC adapter to the USB port of the

camcorder and the other end to a wall outlet.

Connect one end of the supplied USB cable to the USB port of

the camcorder and the other end to a powered PC. Make sure the

camcorder is powered off.

2. The charging LED turns red and the charge starts.

3. When the battery pack is fully charged, the charging LED will turn green.

When using a PC to charge the battery, do not power on the camcorder, or

the charge will stop.

Installing the battery

1. Press the PushEXWWRQ¿UVWDQGVOLGHWKHEDWWHU\FRPSDUWPHQW

cover down.

2. Place the accessory Li-Ion battery into the compartment until it is

locked by the latch. Note that the metallic contacts must be aligned

with the contacts in the compartment.

3. After the battery is properly installed, close the battery

compartment cover.

Charging the battery

Open the LCD monitor or press and hold down the Power button for 1 second to turn on

the camcorder.

To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or

close the LCD monitor.

Turning on/off your camcorder

If the camcorder stays inactive for a long period of time, it may automatically

shut down due to the Auto-Off setting.

1 2 3 4 5 6 7 8 9 10 ... 18 19

Pas de commentaire

AIPTEK A-HD Manuel d'utilisateur Page 5