AIPTEK AHD T8 Pro Spécifications télécharger pdf (Page 3)

Detach the USB connector as indicated,

and then unfasten the battery cover to

remove the cover.

Place the accessory Li-Ion battery into

the compartment. Note that the metallic

contacts must be aligned with the

contacts in the compartment.

Replace the cover.

When using for the rst time, please fully charge the battery for

at least 8 hours.

Getting Started

Loading the battery

Lift the memory card cover to open it as indicated.

Insert the card as the direction of indication until it

reaches the end of the slot.

When the card is inserted successfully, the icon ( ) will

appear on screen. To remove the card, push the card to

release it and then pull it out gently.

Put the cover back.

Detach the USB connector and plug it into a USB port on a powered PC. Make

sure the camcorder is powered off.

The charging LED turns red and the charge starts.

When the charging is interrupted or the battery pack is fully charged, the charging

LED will turn off.

When using a PC to charge the battery:

1) Do not power on the camcorder or the

charge will stop.

2) If necessary, use a USB extension

cable to extend the connection.

Charging the battery

If the power is not turned on after you have completed the above procedures, please

check the following have been done correctly: 1) The battery is correctly loaded; 2) The

loaded battery has enough power.

Please choose your local language before starting using the camcorder.

Icon Description

Full battery life

Moderate battery life

Low battery life

* The ash strobe will be disabled.

Empty battery life

Note: To avoid sudden outage of power supply, you are recommended to replace the

battery when the icon indicates low battery life.

1 2 3 4 5 6 7 8 ... 56 57

Pas de commentaire

AIPTEK AHD T8 Pro Spécifications Page 3